Re: **The Official Vinyl Collectors Thread**
Quote:
Originally Posted by BTBaboon
I know this sounds silly, but my first check is always to make sure all cables are properly plugged in (power to all units, correct alignment of audio output/input, and speaker wire properly connected +/-).
After that, make sure your receiver setting is correct (and not on mute).
If that doesn't do it, there could be an issue. Are you getting ANY sound (even very very quiet sound)? If so, that would point to an issue in your pyle pre-amp. If not, things get a bit trickier. Could be the speakers, could be the receiver, or could be tonearm wiring issues on your TEAC.
|
Try the other receiver inputs too - switch it from SAT/CATV to CD or DVD or whatever and see if you still have the same problem.
|